2008 Dodge Ram Keyless Entry Remote Fob Smart Key Programming Instructions 

 
**This procedure CAN ONLY be used on vehicles built in USA.
 

**You MUST HAVE two working programmed Remote/keys before you can add  a third remote/key. 

**If you only have ONE WORKING REMOTE/KEY and want to add a second key this procedure WILL NOT WORK.

1. Insert the first valid key into the ignition switch. Turn the ignition switch to the 
ON/RUN position for at least three seconds, but no longer than 15 seconds.
Then, Turn the ignition switch to the LOCK position and remove the first key.

2. Insert the second valid key into the ignition switch. Turn the ignition switch to
the ON/RUN position within 15 seconds. After 10 seconds, a chime will sound.
In addition, the Vehicle Security Light will begin to flash. Turn the ignition switch
to the LOCK position and remove the second key.

3. Insert the new key into the ignition switch. Turn the ignition switch to the
ON/RUN position.within 60 seconds. After 10 seconds, a single chime will 
sound. In addition, the Vehicle Security Light will stop flashing. To indicate that
programming is complete, the Vehicle Security Light will turn on again for 
seconds and then turn off.

The new key is now programmed. The Remote Keyless Entry transmitter will
also be programmed during this procedure.

Repeat this procedure to program up to eight keys.